Do you want to increase the longevity of your concrete flooring? Do you want to know the potential mistakes that you have been making for years?

If so, this post will guide you through 5 major mistakes that you should avoid!

Grinding and polishing play an incredibly important role in surface preparation to remove any defects while giving it a beautiful shine.

This post will talk about some of the popular yet common concrete grinding and polishing mistakes to avoid when you are about to start the task.

Let’s discuss them in detail!

Mistake #1: Using the Wrong Concrete Bond

It is one of the major mistakes that many people make during the grinding and polishing procedure. If you use an incorrect concrete bond, then your concrete might not get enough hardness that is needed to bear daily foot traffic. Always keep in mind that the type of tool you use boils down to the hardness of the flooring. Even experts recommend it to use a softer bond for hard concrete. On the other hand, using the incorrect bond would lead to quick tool wear. When you know the right composition before grinding, you would ultimately save both time and money.

Mistake #2: Using the Grinder Too Quickly

Another common mistake that people make while grinding and polishing is that they tend to grind it faster than usual. They frequently use grinders at very high rates to increase the rate of manufacturing. It is all due to severe work pressure which could be a problem. As a result, they frequently use grinders at very high rates to increase the rate of manufacturing. Make sure you avoid grinding at a high speed as it could overheat and may ruin the overall appearance of your floor.

Mistake #3: Not Removing Dust and Debris

Another common mistake that is often observed is that many people failed to remove dust and debris even with specialised equipment. Not only does it make your floor look bad, but it is also conducive to many health ailments that could significantly impact your lungs. Make sure you get rid of the dust and trash as it can gradually build scar tissue in your lungs. To avoid such hazardous issues, make sure you use an industry-standard vacuum that is proven to remove 99.97% of the powdery substance from the air.

Pro Tip: Ensure you start your grinding and polishing job when it’s wet with water.

Mistake #4: Starting Before Inspecting 

Though grinding is an exciting task, it should be done with proper inspection beforehand. It is often observed that many people neglect this scenario and end up losing the glossy appearance of their floor. To ensure the optimal condition of your tools, ensure you check the floor for any “above grade” materials. In addition to being built of a variety of materials, they are also elevated above the floor’s surface. When you overlook the inspection, you are likely to damage your tools, causing potential harm that would require replacement anytime soon.

Mistake #5: Not Cutting Stages

Finally, yet importantly, if you want to ensure your floor must get a flawless look, then you cannot overlook the importance of cutting stages. Ensure you just don’t move straight to 200 grits right after passing through 100 grits. Though it seems to be a time-saver, it might not give you the output that you desire. For instance, if you move to 200 grits right after 150 grits, it will be difficult to eliminate swirls left by the 50 grit. Don’t forget to use cutting pads in segments.

Conclusion

So, the post concludes with the 5 common grinding and polishing mistakes that you should avoid. Don’t let the mistakes overpower you. Just use your skills and get 100% positive outcomes.